Seamless Preview Pixaroma
See a pattern repeat, and let it check the edges for you.
What it is for
A seamless pattern only works if its right edge continues into its left edge and its bottom edge into its top edge. Looking at one picture does not tell you that. This node shows the picture repeated, checks the edges and tells you if they join.
Put it after VAE Decode. It works with any picture, so you can also check a pattern you made somewhere else.
The views
Pick the view in the view dropdown. The face changes at once; the tiled output follows on the next Run.
- Tile
- The picture on its own.
- 2x2 and 3x3
- The picture repeated. A seam shows up as a straight line or a cut through a motif.
- Offset
- The picture moved by half a tile, so the four corners meet in the middle. This is where a seam shows first: look at the middle cross.
- Half-drop
- Every other column moved down by half a tile. Fabric printers such as Spoonflower offer this repeat; it hides a grid feel.
- Half-brick
- Every other row moved right by half a tile, like bricks in a wall.
The edge check
The two chips check each direction: the arrow left and right for the left and right edges, the arrow up and down for the top and bottom edges. Point at a chip for the numbers.
- PASS
- The edge looks like any other line in the picture. It repeats with no visible seam.
- WARN
- The edge is the strongest line in the picture, but only a little. Look at it in Offset; with pictures that have hard lines (planks, tiles, pixel art) this can happen by chance.
- FAIL
- A real seam: the edge stands out from every other line. Most pictures made without Seamless Tile Pixaroma get this.
- N/A
- Not checked: the picture is smaller than 64 px that way, or its pixels are broken (a black picture from a failed run).
Lines
The Lines switch draws a thin line where each tile starts, so you can see the repeat. Turn it off to judge the seam by eye: a line on top would hide it.
Outputs
- image
- The same picture, unchanged. Connect it to a save node.
- tiled
- The picture repeated the way the view shows it, as one bigger picture: 2x2 is twice as wide and tall. Handy for a mock-up or a thumbnail.
A batch
With several pictures in, the arrows next to the chips step through them. The face shows and checks the first 16; the tiled output has all of them.
What you wire in
The settings on the node
This is the help that comes with Pixaroma 1.4.261. Inside ComfyUI, select the node and click the orange ? above it to read the same help there.