Image Compare Pixaroma
See the difference between two images at a glance.
Setup
Wire any two IMAGE outputs into image1 and image2 (before / after upscaling, original / inpainted, two checkpoints, ...) and run the workflow once. Each image's size is shown on the node with a 1 / 2 badge - the sizes turn orange when the two differ.
Missing an image is fine
Both inputs are optional. If only one is connected - for example when a branch feeding one input is muted or bypassed in a workflow that toggles between text-to-image and image-to-image - the node simply shows that one image. If neither is connected it shows a short note. It never throws a system error, so you can leave it in the graph and just ignore it when it has nothing to compare.
View modes
- Show 1 / Show 2
- View one image full-size. Click to switch between the two.
- Left Right / Right Left
- Side-by-side split - hover the image to wipe across. Right Left swaps which side each image is on.
- Up Down
- Top / bottom split - hover to wipe up and down.
- Overlay
- Stack both images and drag the slider, or scroll the mouse wheel over the image, to fade between them.
- Difference
- Highlight only the pixels that differ between the two.
Save buttons (in Show 1 / Show 2)
- Save D
- Save the shown image to disk - opens a dialog so you pick where.
- Save O
- Save the shown image to the ComfyUI output folder.
- Copy
- Copy the shown image to the clipboard.
What you wire in
What comes out
Nothing. This is the end of a chain - it shows or saves what reaches it.
This is the help that comes with Pixaroma 1.4.212. Inside ComfyUI, select the node and click the orange ? above it to read the same help there.