Pause Image Pixaroma
Pause your workflow mid-run to review an image before the expensive part runs.
In ComfyUI: double-click an empty spot on the canvas and type Pause Image Pixaroma.
What it does
Acts as an inline gate on any IMAGE wire. Drop it between an image source (e.g. a KSampler) and expensive downstream work (an upscale, a second pass). In Pause mode only the upstream runs and the image is shown; you then decide whether to continue.
The three modes
- Pause
- Run stops here. The image is shown and a snapshot is saved. The downstream does not run yet.
- Continue
- The upstream is skipped and the saved snapshot is fed downstream. Use this after reviewing, so only the cheaper downstream work runs.
- Pass
- The whole workflow runs end to end, as if this node were not there.
How to use
- Wire your image source into
imageand wire the output onward. - Set the toggle to
Pauseand click Run. Review the image. - Switch to
Continueand click Run again - only the downstream runs, fed from the image you saw. - Use
Regenerateto roll a fresh image at the same point.
Outputs
- image
- The image continuing downstream: the live input in Pause/Pass, or the saved snapshot in Continue.
What you wire in
imageIMAGEoptional
The image to gate. Wire your image source here; the same image flows out the output unchanged when the gate passes or continues.
This is the help that comes with Pixaroma 1.4.212. Inside ComfyUI, select the node and click the orange ? above it to read the same help there.