Krea2 Enhancer Pixaroma

What it does

Krea 2 sometimes skips details you wrote in the prompt. This node makes the model lean harder on the prompt while it draws, so more of what you asked for ends up in the picture.

It does not change your prompt and needs no extra nodes or downloads. It changes nothing on disk either: it works on a copy of the model inside the run.

Where it goes

On the MODEL wire: the Krea 2 model loader, then any LoRA loaders, then Krea2 Enhancer Pixaroma, then the sampler.

Strength

0 does nothing. Higher values push harder on the prompt. Our Krea 2 workflows use 0.1 for most, and 0.5 for most of the extra pass and 2K ones. Try a few values with the same seed and keep the one you like.

Too much can look overcooked, and it can change logos, brand names and lettering. If text in the picture comes out wrong, lower the strength or turn the node off.

Compare with and without

Turn enabled off and Run with the same seed to see the picture without the enhancer, then turn it on again.

Where it comes from

It is the ComfyUI-Krea2T-Enhancer node by capitan01R (MIT licence). Its author removed it from GitHub and the Comfy Registry in October 2026, so the Pixaroma Krea 2 workflows now use this copy. The math is the same, so the pictures match the original node with the same settings and seed.